Effect of low-pressure and oxygen-enriched environment on combustion characteristics of typical fabrics
JIA Xuhong1,2, TANG Jing1, MA Junhao1, TIAN Wei1, ZHANG Xiaoyu1, DAI Shangpei1, DING Sijie1
1. College of Civil Aviation Safety Engineering, Civil Aviation Flight University of China, Guanghan 618307, China; 2. Civil Aircraft Fire Science and Safety Engineering Key Laboratory of Sichuan Province, Civil Aviation Flight University of China, Guanghan 618307, China
Abstract：[Objective] Artificial oxygen enrichment devices are used in several situations to ensure the safety and health of workers and travelers in high-altitude regions, such as in high-altitude airport control command centers, VIP rooms, medical rooms, and luxury hotels. Indoor oxygen enrichment can meet the oxygen supplementation needs of people. However, the flammability of materials is affected in nonstandard atmospheric conditions such as low-pressure and oxygen-rich environments, resulting could cause additional fire hazards.[Methods] This study simulates the combustion of typical indoor fabrics in the Kangding Plateau (60.5 kPa) and Guanghan, Sichuan (95.8 kPa) inside a combustion chamber by adjusting the pressure and oxygen concentration. It explores changes in the core combustion parameters such as flame form, ignition time, mass loss rate, heat release rate, and total heat release amount of pure cotton and polyester at 60.5 kPa and various oxygen concentrations (21.0%, 27.0%, 33.0%, and 39.0%).[Results] Fabric combustion at low pressure involved the stages of thermal decomposition, ignition, intense burning, and flame decay until extinction. In a low-pressure environment with normal oxygen content, complete cotton combustion was achieved, resulting in the formation of residual char that was loose and easily pulverized. In contrast, polyester combustion exhibited an efficiency of only 11.1%, producing a considerable amount of black and brittle residual char. The rates of mass loss and heat release decreased during the combustion of cotton and polyester, resulting in lower flame heights. The ignition time of cotton decreased by 3.6%, while the ignition time of polyester decreased by 7.8%. The duration of combustion increased by 46.8% for cotton and 197.0% for polyester. Additionally, the burning time of melted polyester droplets increased by 296.0%. With an increase in the oxygen concentration, the ignition time of pure cotton and polyester decreased by 19.1% and 25.7%, respectively. The time of peak rates of mass loss and heat release for pure cotton and polyester were reduced by 78.1% and 52.1%, respectively. The flame height of both materials increased, and the peak mass loss rate and heat release rate significantly rised. The combustion efficiency of polyester was improved by 68.1%, and the total heat release was increased by 1.2 times. Additionally, the burning time of melted droplets was increased by 3.1 times. In contrast, the changes in these parameters were not considerable for cotton combustion. The decrease in the partial pressure of nitrogen in a low-pressure environment decreased the flame-retardant effect of the inert nitrogen gas. Thus, if the peak rate of heat release was taken as the criterion for a fire hazard, the combustion fire hazard of fabrics at a pressure of 60.5 kPa and oxygen concentration of 30.0% was equivalent to that of combustion under normal pressure and normal oxygen conditions. [Conclusions] This study analyzes the effects of the changes in oxygen concentration at low air pressure on the combustion characteristics and reveals the fire behavior characteristics of typical combustible materials such as cotton and polyester in low-pressure oxygen-rich environments. It provides a basis for the fire safety design of artificial oxygen enrichment environments in high-altitude regions.
[1] WEST J B. Commuting to high altitude:Value of oxygen enrichment of room air[J]. High Altitude Medicine & Biology, 2002, 3(2):223-235. [2] WEST J B. Safe upper limits for oxygen enrichment of room air at high altitude[J]. High Altitude Medicine & Biology, 2001, 2(1):47-51. [3] 中国民用航空局. 高原机场供氧系统建设和使用医学规范:AC-158-FS-2013-01[S]. 北京:中国民用航空局, 2013. Civil Aviation Administration of China. Medical standards for construction and use of oxygen supply systems at high-altitude airports:AC-158-FS-2013-01[S]. Beijing:Civil Aviation Administration of China, 2013. (in Chinese) [4] 中华人民共和国国家质量监督检验检疫总局, 中国国家标准化管理委员会. 高原地区室内空间弥散供氧(氧调)要求:GB/T 35414-2017[S]. 北京:中国标准出版社, 2017. General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China, Standardization Administration of the People's Republic of China. Requirements of oxygen conditioning for indoor oxygen diffusion in plateau area:GB/T 35414-2017[S]. Beijing:Standards Press of China, 2017. (in Chinese) [5] National Fire Protection Association. Standard for hypobaric facilities:NFPA 99B[S]. Quincy:NFPAInc, 2000. [6] 西藏自治区住房和城乡建设厅. 西藏自治区民用供氧工程设计标准:DBJ 540004-2018[S]. 拉萨:地方标准出版社, 2018. Housing and Urban-Rural Development Department of Tibet Autonomous Region. Design standards for engineering of civil oxygen supply in Tibet Autonomous Region:DBJ 540004-2018[S]. Lhasa:Local Standards Press, 2018. (in Chinese) [7] MOST J M, MANDIN P, CHEN J, et al. Influence of gravity and pressure on pool fire-type diffusion flames[J]. Symposium (International) on Combustion, 1996, 26(1):1311-1317. [8] TU R, ZENG Y, FANG J, et al. The influence of low air pressure on horizontal flame spread over flexible polyurethane foam and correlative smoke productions[J]. Applied Thermal Engineering, 2016, 94:133-140. [9] ALPERT R L. Pressure modeling of fires controlled by radiation[J]. Symposium (International) on Combustion, 1977, 16(1):1489-1500. [10] NAKAMURA Y, AOKI A. Irradiated ignition of solid materials in reduced pressure atmosphere with various oxygen concentrations-for fire safety in space habitats[J]. Advances in Space Research, 2008, 41(5):777-782. [11] OLSON S L, RUFF G A, MILLER F J. Microgravity flame spread in exploration atmospheres:Pressure, oxygen, and velocity effects on opposed and concurrent flame spread[C]//38th International Conference on Environment System, San Francisco, USA:Society of Automotive Engineers International, 2008:2080034883. [12] 孙晓乾, 李元洲, 霍然, 等. 西藏古建筑常用木材的着火特性试验[J]. 中国科学技术大学学报, 2006, 36(1):77-80. SUN X Q, LI Y Z, HUO R, et al. Experimental on ignition characteristics of timber widely used in Tibet's historical buildings[J]. Journal of University of Science and Technology of China, 2006, 36(1):77-80. (in Chinese) [13] 冯瑞, 田润和, 陈科位, 等. 低气压环境对固体燃烧特性影响的实验研究[J]. 清华大学学报(自然科学版), 2019, 59(2):111-121. FENG R, TIAN R H, CHEN K W, et al. Experimental study of the effect of low pressures on solid fuel combustion characteristics[J]. Journal of Tsinghua University (Science and Technology), 2019, 59(2):111-121. (in Chinese) [14] WANG W, WANG L, YANG R, et al. Investigation of the effect of low pressure on fire hazard in cargo compartment[J]. Applied Thermal Engineering, 2019, 158:113775. [15] MA Q J, SHAO J C, WAN M S, et al. Experimental study on the burning behavior of cardboard box fire under low air pressure[J]. Fire and Materials, 2021, 45(2):273-282. [16] KASHIWAGI T, INABA A, BROWN J E, et al. Effects of weak linkages on the thermal and oxidative degradation of poly (methyl methacrylates)[J]. Macromolecules, 1986, 19(8):2160-2168. [17] HAYASHI J I, NAKAHARA T, KUSAKABE K, et al. Pyrolysis of polypropylene in the presence of oxygen[J]. Fuel Processing Technology, 1998, 55(3):265-275. [18] MCALLISTER S, FERNANDEZ-PELLO C, URBAN D, et al. The combined effect of pressure and oxygen concentration on piloted ignition of a solid combustible[J]. Combustion and Flame, 2010, 157(9):1753-1759. [19] SIMONS D G, ARCHIBALD E R. Selection of a sealed cabin atmosphere[J]. The Journal of Aviation Medicine, 1958, 29(5):350-357. [20] FERERES S, LAUTENBERGER C, FERNANDEZ-PELLO C, et al. Mass flux at ignition in reduced pressure environments[J]. Combustion and Flame, 2011, 158(7):1301-1306. [21] FERERES S, LAUTENBERGER C, FERNANDEZ-PELLO A C. Understanding ambient pressure effects on piloted ignition through numerical modeling[J]. Combustion and Flame, 2012, 159(12):3544-3553. [22] LIU Y S, JIA Y X, WU T Y, et al. Technologies of oxygen supply for life support during the development of mineral resources in high altitude areas[J]. Engineering Sciences, 2013, 11(2):68-75. [23] 刘应书, 杨雄, 沈民, 等. 低气压富氧环境对薄壁材料火焰传播速度的影响[J]. 燃烧科学与技术, 2010, 16(3):199-203. LIU Y S, YANG X, SHEN M, et al. Effect of low barometric pressure and oxygen-enriched atmosphere on flame spreading velocity over thin materials[J]. Journal of Combustion Science and Technology, 2010, 16(3):199-203. (in Chinese) [24] THOMSEN M, FERNANDEZ-PELLO C, OLSON S L, et al. Downward burning of PMMA cylinders:The effect of pressure and oxygen[J]. Proceedings of the Combustion Institute, 2021, 38(3):4837-4844. [25] 中华人民共和国国家质量监督检验检疫总局, 中国国家标准化管理委员会. 纺织品燃烧性能垂直方向损毁长度、阴燃和续燃时间的测定:GB/T 5455-2014[S]. 北京:中国标准出版社, 2014. General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China, Standardization Administration of the People's Republic of China. Textiles-burning behaviour-determination of damaged length, afterglow time and afterflame time of vertically oriented specimens:GB/T 5455-2014[S]. Beijing:Standards Press of China, 2014. (in Chinese). [26] RICH D, LAUTENBERGER C, TORERO J L, et al. Mass flux of combustible solids at piloted ignition[J]. Proceedings of the Combustion Institute, 2007, 31(2):2653-2660. [27] HIRATA T, KASHIWAGI T, BROWN J E. Thermal and oxidative degradation of poly (methyl methacrylate):Weight loss[J]. Macromolecules, 1985, 18(7):1410-1418.
2024, Vol. 64 
