Abstract：[Objective] Full-model flutter test is crucial for the aeroelastic design and verification of aircraft. One of the key challenges of the test is ensuring that the model's suspension design meets the natural frequency and motion adjustment range requirements. This study proposes a cable suspension system with four cables/three springs for the full-model flutter wind tunnel test under transonic conditions to address the current research gap in verifying suspension systems other than the existing two-cable or three-cable suspension mechanisms. The designed four-cable suspension method is expected to offer distinct advantages for transonic wind tunnel tests, such as suitability for the static unstable aircraft models and their intelligent controls. [Method] The stability and kinematic characteristics of the proposed four-cable suspension system are analyzed and validated through a series of methods. First, the stiffness expression of the mechanism is established based on the differential kinematics and used for deriving the stability criterion in light of the principle of virtual work by considering the system dynamic equations and the aerodynamic model of the aircraft. Subsequently, the eigenvalues of the stiffness and aerodynamic derivatives matrix are determined, and the pose variations of the aircraft model subjected to aerodynamic forces are numerically investigated to demonstrate the suitability of the suspension system for static unstable aircraft models. Additionally, the system impact response and the factors influencing its frequency are studied, proving that the four-cable suspension system meets the natural frequency requirements of the full-model flutter wind tunnel test. Numerical calculations and Adams software simulations are performed to verify that the four-cable suspension system can achieve effective adjustment of the aircraft model pose by controlling the cable length and manipulating the aileron and rudder surfaces. Finally, a simple prototype is built for modal frequency experiments to verify the feasibility of the proposed theoretical method. [Results] The simulation and numerical calculation results demonstrated that the proposed four-cable suspension method was a viable solution for the full-model flutter wind tunnel test under transonic conditions, providing five degrees of freedom to the model. The high-speed incoming flow dynamic response results revealed that the four-cable suspension system exhibited outstanding stability, with the largest magnitude observed in the centroid displacement along the sideslip direction of the aircraft model, which was less than 0.04 m, while the rotational angle amplitudes did not exceed 15.0°. The initial pre-tension force could be adjusted to ensure that the cable continuously remained in tension. Furthermore, the natural frequencies of the mechanism in the three rotation directions were approximately 0.8~1.0 Hz, and the natural frequencies in the sideslip and heave directions were within 3.0 Hz. The study also examined the influence of different traction positions and spring numbers on the natural frequency and revealed that the attitude angle adjustment range of the four-cable suspension system with three springs could meet the requirements of the test through cable length adjustment and rudder surface control. The simple prototype frequency experiment demonstrated that the roll, pitch, and yaw direction modal frequencies were less than 3.0 Hz. [Conclusion] This study demonstrates the feasibility of using the proposed four-cable suspension system for transonic full-model flutter wind tunnel testing through numerical calculations, software simulations, and prototype experiments, providing a approach for the model suspension technology in transonic full-model flutter test.
江海龙, 王晓光, 王家骏, 柳汀, 林麒. 全模颤振四绳支撑系统运动特性与稳定性[J]. 清华大学学报（自然科学版）, 2023, 63(11): 1856-1867.
JIANG Hailong, WANG Xiaoguang, WANG Jiajun, LIU Ting, LIN Qi. Kinematic characteristics and stability analysis of four-cable suspension system for full-model flutter wind tunnel test. Journal of Tsinghua University(Science and Technology), 2023, 63(11): 1856-1867.
[1] 杨超,吴志刚,万志强,等.飞行器气动弹性原理[M].北京:北京航空航天大学出版社, 2011. YANG C, WU Z G, WAN Z Q, et al. Aeroelastic principle of aircraft[M]. Beijing:Beihang University Press, 2011.(in Chinese) [2] 陆志良,郭同庆,管德.跨音速颤振计算方法研究[J].航空学报, 2004, 25(3):214-217. LU Z L, GUO T Q, GUAN D. A study of calculation method for transonic flutter[J]. Acta Aeronautica et Astronautica Sinica, 2004, 25(3):214-217.(in Chinese) [3] 吴志刚,杨超.机翼的气动伺服弹性设计优化研究[J].航空学报, 2006, 27(4):570-573. WU Z G, YANG C. Aeroservoelastic design optimization of flexible wings[J]. Acta Aeronautica et Astronautica Sinica, 2006, 27(4):570-573.(in Chinese) [4] 崔鹏,韩景龙.基于CFD/CSD的非线性气动弹性分析方法[J].航空学报, 2010, 31(3):480-486. CUI P, HAN J L. Investigation of nonlinear aeroelastic analysis using CFD/CSD[J]. Acta Aeronautica et Astronautica Sinica, 2010, 31(3):480-486.(in Chinese) [5] 杨国伟,钱卫.飞行器跨声速气动弹性数值分析[J].力学学报, 2005, 37(6):769-776. YANG G W, QIAN W. Numerical analyses of transonic flutter on an aircraft[J]. Chinese Journal of Theoretical and Applied Mechanics, 2005, 37(6):769-776.(in Chinese) [6] 路波,吕彬彬,罗建国,等.跨声速风洞全模颤振试验技术[J].航空学报, 2015, 36(4):1086-1092. LU B, LV B B, LUO J G, et al. Wind tunnel technique for transonic full-model flutter test[J]. Acta Aeronautica et Astronautica Sinica, 2015, 36(4):1086-1092.(in Chinese) [7] RIVERA J A, FLORANCE J R. Contributions of transonic dynamics tunnel testing to airplane flutter clearance[C]//41st Structures, Structural Dynamics, and Materials Conference and Exhibit. Atlanta, USA:AIAA, 2000:AIAA-2000-1768. [8] LIVNE E, WEISSHAAR T A. Aeroelasticity of nonconventional airplane configurations-past and future[J]. Journal of Aircraft, 2003, 40(6):1047-1065. [9] COLE S R, NOLL T E, PERRY B. Transonic dynamics tunnel aeroelastic testing in support of aircraft development[J]. Journal of Aircraft, 2003, 40(5):820-831. [10] REED W H, ABBOTT F T. A new "free-flight" mount system for high-speed wind-tunnel flutter models[R/OL].[2023-02-01]. https://www.zhangqiaokeyan.com/ntis-science-report_other_thesis/020711162592.html. [11] GLAZKOV S A, GORBUSHIN A R, KHOZIAENKO N N, et al. Investigation of the rear support interference on the aerodynamic characteristics of the RRJ-95 model in the T-128 transonic wind tunnel[C]//International Congress on Instrumentation in Aerospace Simulation Facilities. Sendai, Japan:IEEE, 2005:76-82. [12] 唐建平,杨远志,梁鉴.低速全模颤振试验悬挂支撑系统[J].实验流体力学, 2014, 28(4):65-69. TANG J P, YANG Y Z, LIANG J. Floating suspension system for full model flutter tests at low speed[J]. Journal of Experiments in Fluid Mechanics, 2014, 28(4):65-69.(in Chinese) [13] 郭洪涛,路波,余立,等.某战斗机高速全模颤振风洞试验研究[J].航空学报, 2012, 33(10):1765-1771. GUO H T, LU B, YU L, et al. Investigation on full-model flutter of a certain fighter plane in high-speed wind tunnel test[J]. Acta Aeronautica et Astronautica Sinica, 2012, 33(10):1765-1771.(in Chinese) [14] 钱卫,杨国伟,张桂江,等.某全机跨声速颤振模型颤振特性仿真与试验验证[J].空气动力学学报, 2014, 32(3):364-368. QIAN W, YANG G W, ZHANG G J, et al. Flutter characteristic simulation and experimental verification for transonic flutter model of a whole aircraft[J]. Acta Aerodynamica Sinica, 2014, 32(3):364-368.(in Chinese) [15] 赵冬强,胡志勇,高宏.全机颤振风洞试验模型地面共振试验影响因素分析[J].航空科学技术, 2015, 26(7):61-65. ZHAO D Q, HU Z Y, GAO H. Affecting factors analysis of GVT for aircraft flutter wind tunnel model[J]. Aeronautical Science&Technology, 2015, 26(7):61-65.(in Chinese) [16] 于金革,由亮,王昊,等.一种大型低速风洞颤振试验全模支撑装置:112014060A[P]. 2020-12-01. YU J G, YOU L, WANG H, et al. A full-model support device for flutter test in large low-speed wind tunnel:112014060A[P]. 2020-12-01.(in Chinese) [17] 赵振军,闫昱,曾开春,等.全模颤振风洞试验三索悬挂系统多体动力学分析[J].航空学报, 2020, 41(11):123934. ZHAO Z J, YAN Y, ZENG K C, et al. Multibody dynamics analysis of three-cable mount system for full-mode flutter wind tunnel test[J]. Acta Aeronautica et Astronautica Sinica, 2020, 41(11):123934.(in Chinese) [18] 吴太欢,林麒,何升杰,等.全模颤振双索悬挂系统刚体模态频率研究[J].航空学报, 2020, 41(9):123761. WU T H, LIN Q, HE S J, et al. Rigid body modal frequencies of two cables suspension system for full-model flutter[J]. Acta Aeronautica et Astronautica Sinica, 2020, 41(9):123761.(in Chinese) [19] 李剑锋,王新华,魏源迁,等. 3-RSR并联机构的微分运动学及动力学分析[J].北京工业大学学报, 2003, 29(4):418-423. LI J F, WANG X H, WEI Y Q, et al. Differential kinematic and dynamic analysis of 3-RSR parallel mechanism[J]. Journal of Beijing University of Technology, 2003, 29(4):418-423.(in Chinese) [20] SURDILOVIC D, RADOJICIC J. Practical stability of under-constrained cable-suspended parallel robots[M]//POTT A, BRUCKMANN T. Cable-driven parallel robots. Cham:Springer, 2019:85-98. [21] 王延灵,卜忱,冯帅,等.大迎角横向状态空间气动力建模研究[J].飞行力学, 2021, 39(4):13-18. WANG Y L, BU C, FENG S, et al. Modeling of lateral state-space of aerodynamic characteristics at high angle of attack[J]. Flight Dynamics, 2021, 39(4):13-18.(in Chinese) [22] HANDOJO V A, SYAMLAN A T, Nurahmi L, et al. Cable driven parallel robot with big interference-free workspace[M]//SEN D, MOHAN S, ANANTHASURESH G K. Mechanism and machine science. Singapore:Springer, 2021:43-56.
2023, Vol. 63 
