| PUBLIC SAFETY |
|
|
|
|
|
Experimental analyses and modeling of pool fires with different ullage heights |
| ZHU Huacheng1, HU Zhenqi1, ZHAO Zhishan1, CHEN Cheng1, ZHAO Jinlong1, YANG Rui2 |
1. School of Emergency Management and Safety Engineering, China University of Mining and Technology(Beijing), Beijing 100083, China;
2. Department of Engineering Physics, Tsinghua University, Beijing 100084, China |
|
|
|
|
Abstract ［Objective］ In recent years, floating-roof tanks have been widely used for liquid fuel storage in China. However, these tanks suffer from a considerable fire risk owing to the accumulation of highly flammable fuel vapors when the liquid fuel level is low. The risk of pool fires, confined by ullage heights, seriously threatens fuel storage and transportation. Furthermore, the flame characteristics, including burning rates and flame heights, are notably affected by ullage heights. However, the research on pool fires with different ullage heights is few. Hence, this study aims to experimentally study the pool fires for different ullage heights and analyze the key parameters (burning rate and flame height). Additionally, a correlation based on dimensionless analysis is proposed to predict the down-reaching flame height. ［Methods］ This study investigates the effect of ullage heights on pool fires. A series of pool fire experiments were conducted using a transparent quartz glass tray and heptane fuel. Different ullage heights (ranging from 3 cm to 50 cm, measured as the vertical distance from the tank top to the liquid fuel surface) were considered. The burning rate was measured using a Sartorius balance and video cameras were installed to record the burning process and flame heights. Flame heights were calculated by converting the flame videos into binary images. Subsequently, the key parameters were analyzed. ［Results］ The experimental results reveal the following: (1) The ullage height considerably affects the burning process, particularly at the initial and steady stages. At the initial stage, the burning rate sharply increases for cases with a low ullage height, while a burning rate decrease trend is observed after the rapid increase for cases with a large ullage height. This is mainly caused by the continuous uplift of the flame base, moving away from the fuel surface. (2) At the steady stage, the burning rate first decreases and then increases, followed by a final decrease with the increase of the ullage height. The increase in the distance between the flame base and the fuel surface results in this burning rate decrease trend. The burning rate increases because the flame base enters the tray. (3) Based on the flame shape in cases with a large ullage height in the steady stage, total flame height can be divided into the upper flame height outside the tray and the down-reaching flame height inside the tray. The experimental data demonstrates that the upper flame height decreases as the ullage height increases, whereas the down-reaching flame height shows an opposite trend. (4) A correlation is developed using the experimental data and dimensionless analysis to calculate down-reaching flame height with different ullage heights, in which the characteristic tray diameter is revised by considering the influence of ullage heights and air entrainment. ［Conclusions］ The findings of this study will contribute to the understanding of the burning behaviors of fires at different ullage heights, with practical implications in providing guidance for quantitative risk assessment in tank fires.
|
| Keywords
pool fire
ullage height
burning rate
flame height
air entrainment
|
|
Issue Date: 01 September 2023
|
|
|
[1] WACHTMEISTER H, HENKE P, HÖÖK M. Oil projections in retrospect:Revisions, accuracy and current uncertainty[J]. Applied Energy, 2018, 220:138-153.
[2] POUYAKIAN M, JAFARI M J, LAAL F, et al. A comprehensive approach to analyze the risk of floating roof storage tanks[J]. Process Safety and Environmental Protection, 2021, 146:811-836.
[3] 周锋,阮桢.石油化工储罐火灾事故统计与分析[C]//2016中国消防协会科学技术年会论文集.南京:中国消防协会, 2016:21-23. ZHOU F, RUAN Z. Statistics and analysis of petrochemical tank fire accidents[C]//Proceedings of 2016 Science and Technology Annual Conference of China Fire Protection Association. Nanjing:China Fire Protection Association, 2016:21-23.(in Chinese)
[4] 河北省应急管理厅.沧州市渤海新区南大港东兴工业区鼎睿石化有限公司"5·31 "火灾事故调查报告[EB/OL].(2021-09-27)[2023-02-05] . https://www.sohu.com/a/492490845_121106832. Department of Emergency Management of Hebei Province. Investigation report on" May 31"fire accident of Dingrui Petrochemical Co., Ltd., Bohai New District, Cangzhou[EB/OL].(2021-09-27)[2023-02-05] . https://www.sohu.com/a/492490845_121106832.(in Chinese)
[5] BLINOV V I, KHUDIAKOV G N. Diffusion burning of liquids:NTIS No. AD296762[R]. Moscow:Academy of Sciences, 1961:105-108.
[6] HESKESTAD G. Peak gas velocities and flame heights of buoyancy-controlled turbulent diffusion flames[J]. Symposium (International) on Combustion, 1981, 18(1):951-960.
[7] 庄磊.航空煤油池火热辐射特性及热传递研究[D].合肥:中国科学技术大学, 2008. ZHUANG L. Study on thermal radiation character and heat transfer of aviation fuel pool fires[D]. Hefei:University of Science and Technology of China, 2008.(in Chinese)
[8] LEI J, DENG W Y, MAO S H, et al. Flame geometric characteristics of large-scale pool fires under controlled wind conditions[J]. Proceedings of the Combustion Institute, 2023, 39(3):4021-4029.
[9] KOLSTAD E A, FRETTE V, KRAUSE U, et al. Lip-height effect in diffusive pool fires[J]. Fire Safety Journal, 2021, 125:103428.
[10] HE P X, XU R Z, LIU Q, et al. The evolution of flame length for the oil tank fire with different top cover widths and lip heights[J]. Journal of Loss Prevention in the Process Industries, 2020, 64:104070.
[11] SHI X C, SAHU A K, NAIR S, et al. Effect of ullage on burning behavior of small-scale pool fires in a cavity[J]. Proceedings of the Combustion Institute, 2017, 36(2):3113-3120.
[12] KUANG C, HU L H, ZHANG X L, et al. An experimental study on the burning rates of n-heptane pool fires with various lip heights in cross flow[J]. Combustion and Flame, 2019, 201:93-103.
[13] 党晓贝,何亚平,汪箭.不同边沿高度油池火燃烧行为的实验和数值模拟研究[J].火灾科学, 2018, 27(4):213-221. DANG X B, HE Y P, WANG J. Experimental and numerical study on burning behavior of pool fire with different lip heights[J]. Fire Safety Science, 2018, 27(4):213-221.(in Chinese)
[14] 党晓贝.不同边沿高度条件下正庚烷油池火燃烧特性研究[D].合肥:中国科学技术大学, 2018. DANG X B. Study on burning behaviour of heptane pool fire with various lip heights[D]. Hefei:University of Science and Technology of China, 2018.(in Chinese)
[15] LIU C X, DING L, JANGI M, et al. Effects of ullage height on heat feedback and combustion emission mechanisms of heptane pool fires[J]. Fire Safety Journal, 2021, 124:103401.
[16] ZHAO J L, ZHANG X, ZHANG J P, et al. Experimental study on the flame length and burning behaviors of pool fires with different ullage heights[J]. Energy, 2022, 246:123397.
[17] ZUKOSKI E E, CETEGEN B M, KUBOTA T. Visible structure of buoyant diffusion flames[J]. Symposium (International) on Combustion, 1985, 20(1):361-366.
[18] YAO Y Z, LI Y Z, INGASON H, et al. Theoretical and numerical study on influence of wind on mass loss rates of heptane pool fires at different scales[J]. Fire Safety Journal, 2021, 120:103048.
[19] ZHAO J L, HUANG H, JOMAAS G, et al. Experimental study of the burning behaviors of thin-layer pool fires[J]. Combustion and Flame, 2018, 193:327-334.
[20] NASR A, SUARD S, EL-RABII H, et al. Heat feedback to the fuel surface of a pool fire in an enclosure[J]. Fire Safety Journal, 2013, 60:56-63.
[21] DRYSDALE D. An introduction to fire dynamics[M]. 3rd ed. Chichester:John Wiley&Sons, 2011.
[22] TU R, ZENG Y, FANG J, et al. Low air pressure effects on burning rates of ethanol and n-heptane pool fires under various feedback mechanisms of heat[J]. Applied Thermal Engineering, 2016, 99:545-549.
[23] ZHAO J L, HUANG H, LI Y T, et al. Experimental and modeling study of the behavior of a large-scale spill fire on a water layer[J]. Journal of Loss Prevention in the Process Industries, 2016, 43:514-520.
[24] HAMINS A, KASHIWAGI T, BURCH R. Characteristics of pool fire burning[C]//American Resistance of Industrial Fluids. Indianapolis, 1995.
[25] GE F L, SIMEONI A, JI J, et al. Experimental study on the evolution of heat feedback in multiple pool fires[J]. Proceedings of the Combustion Institute, 2021, 38(3):4887-4895.
[26] ARTEMENKO E S, BLINOV V I. Burning of liquids in vessels with change of level[J]. Combustion Explosion and Shock Waves, 1968, 4:39-42.
[27] BABRAUSKAS V. Estimating large pool fire burning rates[J]. Fire Technology, 1983, 19(4):251-261.
[28] LIU C X, DING L, JANGI M, et al. Experimental study of the effect of ullage height on flame characteristics of pool fires[J]. Combustion and Flame, 2020, 216:245-255. |
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
| |
Shared |
|
|
|
|
| |
Discussed |
|
|
|
|
2023,
Vol. 63
