Mitigation of negative unsprung mass effects based on motor suspension and battery pack layout

WU Peibao, LUO Rongkang, MA Hui, HOU Zhichao

Journal of Tsinghua University(Science and Technology) ›› 2026, Vol. 66 ›› Issue (11) : 2374-2382.

PDF(2097 KB)
PDF(2097 KB)
Journal of Tsinghua University(Science and Technology) ›› 2026, Vol. 66 ›› Issue (11) : 2374-2382. DOI: 10.16511/j.cnki.qhdxxb.2026.28.030
MECHANICAL ENGINEERING

Mitigation of negative unsprung mass effects based on motor suspension and battery pack layout

  • {{article.zuoZhe_EN}}
Author information +
History +

Abstract

[Objective] In-wheel motor drive, featuring a short driveline, flexible chassis packaging, and independently controllable wheel torques, is a promising route for an integrated electric vehicle chassis. However, the increased unsprung mass not only decreases ride comfort and tire road-holding ability but also exposes the motors to continual road impacts. Active control schemes can be costly, complex, and limited in vibration suppression around the wheel-hop frequency. To mitigate the negative effects of the increased unsprung mass, this study proposes a passive solution that combines motor suspension and a front-and-rear split battery pack layout. [Methods] For comparison, two in-wheel motor drive configurations are selected as benchmarks: one with and one without motor suspension, both with a centrally arranged battery pack. First, lumped-mass models are established for half-car models of the two baseline vehicles and the proposed configuration, to describe the vertical and pitch motions of the vehicle body, as well as the vertical motions of the wheels and motors. Typical dynamic performance indicators are derived, including body vertical acceleration, body pitch angular acceleration, dynamic tire load, motor vertical acceleration, and motor suspension deflection. Subsequently, multibody dynamics models are built in ADAMS/Car for corresponding full cars, consisting of double-wishbone body suspensions, Pacejka tires, the vehicle body system, and the in-wheel motor drive system. Simulations are performed in ADAMS/Car to evaluate the vertical dynamic performance of the three configurations, where the vehicle runs on an ISO 8608 class-E random road at 5 m/s, 10 m/s, 20 m/s, and 30 m/s and on a bump road with a height of 0.02 m and a wavelength of 1 m at 5 m/s. [Results] Typical results on the class-E road at 20 m/s show that, compared with the baseline configuration without motor suspension, the proposed configuration reduces the root mean square (RMS) values of body vertical acceleration, body pitch angular acceleration, dynamic tire load, and motor vertical acceleration by 24.18%, 28.10%, 26.73%, and 43.96%, respectively. Moreover, the proposed configuration further reduces body pitch angular acceleration by 20.83% relative to the configuration with motor suspension only, because the front-and-rear battery pack layout increases the sprung pitch moment of inertia. Frequency-domain results confirm that motor suspension suppresses responses in the 4-10 Hz range, while the split battery layout provides an additional pitch-control benefit. The combined configuration also significantly reduces vibration peaks under the bump-road condition, where the body vertical acceleration, dynamic tire load, motor acceleration, and body pitch angular acceleration decrease by approximately 30%, 27%, 15%, and 50%, respectively, compared with the baseline configuration without motor suspension. Additionally, motor suspension deflection is limited to less than 3 mm in RMS on the class-E random road and to a maximum of 11 mm on the bump road, satisfying the allowable safety requirements for the in-wheel space. [Conclusions] By combining motor suspension and a split battery pack layout, the proposed configuration uses the motor to absorb wheel vibration energy and battery mass redistribution to improve pitch dynamics. The solution mitigates the negative dynamic effects of the increased unsprung mass on in-wheel motor driving vehicles and provides better overall performance in ride comfort, tire road-holding ability, and motor operating reliability.

Key words

in-wheel motor drive / negative dynamic effects / motor suspension / split battery-pack layout / combined configuration

Cite this article

Download Citations
WU Peibao, LUO Rongkang, MA Hui, HOU Zhichao. Mitigation of negative unsprung mass effects based on motor suspension and battery pack layout[J]. Journal of Tsinghua University(Science and Technology). 2026, 66(11): 2374-2382 https://doi.org/10.16511/j.cnki.qhdxxb.2026.28.030

References

[1] 吴佩宝, 罗荣康, 俞志豪, 等. 基于半车模型的轮毂驱动车辆簧下质量影响研究[J]. 清华大学学报(自然科学版), 2024, 64(8): 1445-1455. WU P B, LUO R K, YU Z H, et al. Research on the unsprung mass effect of in-wheel motor drives based on a half-vehicle model[J]. Journal of Tsinghua University (Science and Technology), 2024, 64(8): 1445-1455. (in Chinese)
[2] TAN D, LU C, ZHANG X Y. Dual-loop PID control with PSO algorithm for the active suspension of the electric vehicle driven by in-wheel motor[J]. Journal of Vibroengineering, 2016, 18(6): 3915-3929.
[3] KATSUYAMA E, OMAE A. Improvement of ride comfort by unsprung negative skyhook damper control using in-wheel motors[J]. SAE International Journal of Alternative Powertrains, 2016, 5(1): 214-221.
[4] NIE S D, ZHUANG Y, CHEN F, et al. A method to eliminate unsprung adverse effect of in-wheel motor-driven vehicles[J]. Journal of Low Frequency Noise, Vibration and Active Control, 2018, 37(4): 955-976.
[5] NAGAYA G. In-wheel motor system: 7287611 B2[P]. 2007-10-30.
[6] 罗荣康, 马辉, 俞志豪, 等. 基于系统化设计的内悬置电动轮构型[J]. 清华大学学报(自然科学版), 2025, 65(10): 1920-1929. LUO R K, MA H, YU Z H, et al. Suspended in-wheel motor configuration based on systematic design[J]. Journal of Tsinghua University (Science and Technology), 2025, 65(10): 1920-1929. (in Chinese)
[7] MENG L S, ZOU Y J, QIN Y D, et al. A new electric wheel and optimization on its suspension parameters[J]. Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2020, 234(12): 2759-2770.
[8] TIAN M J, GAO B Z. Dynamics analysis of a novel in-wheel powertrain system combined with dynamic vibration absorber [J]. Mechanism and Machine Theory, 2021, 156: 104148.
[9] ZHAO P P, FAN Z M. Design, modeling, and research on vertical performance of a drive system with in-wheel motor as dynamic vibration absorber[J]. Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2023, 237(4): 862-877.
[10] WANG R C, JIANG Y, DING R K, et al. Design and experimental verification of self-powered electromagnetic vibration suppression and absorption system for in-wheel motor electric vehicles [J]. Journal of Vibration and Control, 2022, 28(19-20): 2544-2555.
[11] MAZUMDER H, EKTESABI M, KAPOOR A. Effect of mass distribution on cornering dynamics of retrofitted EV[C]// Proceedings of the 2012 IEEE International Electric Vehicle Conference. Greenville, USA: IEEE, 2012: 1-6.
[12] SURIYAMOORTHY S, GUPTA S, KUMAR D P, et al. Parametric evaluation of ride comfort and traction stability of hub motor driven electric trucks[C]// Proceedings of the 2019 IEEE Transportation Electrification Conference (ITEC-India). Bengaluru, India: IEEE, 2019: 1-6.
[13] TIAN M J, HU Q Y, GAO B Z, et al. Design and handling dynamic analysis of electric vehicle chassis with yaw direction oscillatable battery pack[J]. Vehicle System Dynamics, 2022, 60(3): 951-972.
[14] KOPYLOV S, ZHENG S F, HOU Z C. A new paradigm in mass distribution for electric vehicles equipped with in-wheel motors [J]. Vehicle System Dynamics, 2026, 64(5): 1003-1021.
[15] 吴佩宝, 罗荣康, 俞志豪, 等. 轮毂驱动汽车簧下质量负效应的被动控制[J]. 清华大学学报(自然科学版), 2025, 65(5): 930-939. WU P B, LUO R K, YU Z H, et al. Passive control on the negative unsprung-mass effects with in-wheel motor driving vehicles[J]. Journal of Tsinghua University (Science and Technology), 2025, 65(5): 930-939. (in Chinese)
[16] 余志生. 汽车理论[M]. 5版. 北京: 机械工业出版社, 2009. YU Z S. Automobile Theory[M]. 5th ed. Beijing: China Machine Press, 2009. (in Chinese)
PDF(2097 KB)

Accesses

Citation

Detail

Sections
Recommended

/

〈 〉